Bosch GLM 100-25 C - Basic Settings Menu

14 | English
The front edge of the measuring tool (e.g. when measuring from a table edge)
The centre of the tripod thread(17) (e.g. for tripod measurements)
Press the soft button to open the Basic settings menu.
Select .
Use the button or button to select the required reference level.
To confirm the selection, press the button.
Swinging the stop pin(8)in and out by 180° is automatically detected and the corres-
ponding reference level suggested. To confirm the selection, press the button.
The rear edge of the measuring tool is preset as the reference level every time the measur-
ing tool is switched on.
Basic Settings Menu
In the Basic settings menu, you can find the following basic settings:
– Switching on and off Bluetooth®
– Changing the reference level(see "Selecting the Reference Level", page13)
– Timer
– Switching on and off permanent laser beam
– Grade measurement calibration (see "Accuracy Check", page36)
– Target display calibration
– Setting the language
– Setting Date & Time
– Changing the unit of measurement
– Changing the Unit of Measurement of an Angle
– Activating PRO360
– Calling up Device Information
– Switching audio signals on and off
– Adjusting the Cut-Off Time
1 609 92A 7E1 | (14.12.2021) Bosch Power Tools