16 | English
Measurement follows after the selected time span. The measured value is displayed in
the result line(a). The time span from release to measurement is displayed in the
status bar at the top.
Continuous measurement and minimum/maximum measurement are not possible when
the timer function is set. The timer stays set until the measuring tool is switched off or un-
til the timer is switched off in the "Settings" menu.
Permanent Laser Beam
The laser beam can be set to be permanently switched on.In this setting, the laser beam
also remains switched on between measurements. Just a single brief press of the but-
ton is necessary for measuring.
Briefly press the button or press and hold the button to open the Basic set-
tings menu.
Select .
To change the selection, press the button or the button.
To confirm the selection, press the button.
To exit the Basic settings menu, press the button or the button.
The continuous laser beam can be switched off again in the settings or automatically when
the measuring tool is switched off.
Setting the Language
Briefly press the button or press and hold the button to open the Basic set-
tings menu.
Select the Tool settings menu.
Select and confirm the selection with the button.
To change the selection, press the button or the button.
To confirm the selection, press the button.
To exit the Basic settings menu, press the button or the soft button.
1 609 92A 7E1 | (14.12.2021) Bosch Power Tools
To Next Page
Loading...
