24 | English
Press the button to start the second measurement, e.g. the width of a room.
Press the button to start the third measurement, e.g. the height of a room.
09.08.2021
13:20
0.0º
m
4.640
m
9.279
m
13.919
599.276 m
3
After the third measurement has been completed, the volume
will be automatically calculated and displayed. The result is
displayed in the result line(a). The individual measured val-
ues are in the measured value lines(h).
Indirect distance measurement
Indirect distance measurement is used to measure distances that cannot be measured dir-
ectly because an obstacle would obstruct the laser beam or no target surface is available
as a reflector. This measuring procedure can only be used in a vertical direction. Any devi-
ation in a horizontal direction leads to measuring errors.
Indirect distance measurement is always less accurate than direct distance measurement.
For application-related reasons, measuring errors can be greater than with direct distance
measurement. To improve measuring accuracy, the use of a tripod (accessory) is recom-
mended.
When using a tripod, observe the set reference level. (see "Selecting the Reference
Level", page13)
The laser beam remains switched on between the individual measurements.
For indirect distance measurement, 4 measuring functions are available, with which dif-
ferent sections can be respectively determined:
– Indirect height measurement
– Double indirect height measurement
– Indirect length measurement
– Trapezoid measurement
1 609 92A 7E1 | (14.12.2021) Bosch Power Tools
To Next Page
Loading...
