Bosch GLM 100-25 C - Continuous Measurement

32 | English
1° 2° 3°
The bottom of the measuring tool is used as the reference
level for the digital spirit level.
To use the digital spirit level, place the measuring tool with
the rear side on the surface to be measured.
You can freeze the measured value by pressing the
button.
When the inclination exceeds 3°, the ball in the display
lights up red.
88.0°
The left-hand side of the measuring tool serves as the refer-
ence level for grade measurement. If the display flashes dur-
ing measurement, the measuring tool has been tipped too
heavily to the side.
To use the grade measurement, place the measuring tool
with one side on the object to be measured.
You can freeze the measured value by pressing the
button.
Continuous Measurement
During continuous measurement, the measured value is continually updated. You can, for
example, move a required distance away from a wall while reading off the current distance
at all times.
Press the button to open the Functions menu.
Select continuous measurement and confirm the selection with the button.
Briefly press the button to switch on the laser.
Move the measuring tool until the required distance is displayed in the result line.
You can interrupt the continuous measurement by briefly pressing the button.
Press the button again to continue the continuous measurement.
1 609 92A 7E1 | (14.12.2021) Bosch Power Tools