10 | English
2 609 141 148 | (24.1.14) Bosch Power Tools
Laser beam diameter (at 25 °C) approx.
–at 10m distance
–at 80m distance
6mm
48 mm
Setting accuracy of the laser to the housing, approx.
–Vertical
– Horizontal
±2mm/m
G)
±10mm/m
G)
Automatic switch-off after approx.
–Laser
– Measuring tool (without measurement)
20 s
5min
Weight according to EPTA-Procedure 01/2003
0.14 kg
Dimensions
51x111x30mm
Degree of protection
IP 54 (dust and splash water protected)
Data transmission
Bluetooth® Bluetooth® 4.0 (Classic and Low Energy)
I)
Micro USB cable
– Charging voltage
– Charging current
USB 2.0
5.0 V
500 mA
Battery Li-Ion
Rated voltage
3.7 V
Capacity
1.25 Ah
Number of battery cells
1
Single measurements per battery charge, approx.
25000
H)
Battery Charger
Article number 2 609 120 4..
Charging time
approx. 3 h
Output voltage
5.0 V
Charging current
500 mA
Protection class
/II
Digital Laser Rangefinder GLM 100 C
A) For measurements from the rear measuring-tool edge, the operating range increases the better the laser light is reflected from the surface of the
target (dispersive, not reflective) and the brighter the laser point is with respect to the ambient brightness (indoors, twilight). For distances greater
than 80 m, we recommend using a retroreflective target plate (accessory). For distances below 20 m, a retroreflective target plate should not be used,
as it can lead to measuring errors.
B) For measurements from the rear measuring-tool edge, 100 % reflectance of the target (e.g., a white-painted wall), weak backlight and 25 °C oper-
ating temperature. Additionally, a deviation influence of ±0.05 mm/m must be taken into account.
C) For measurements from the rear measuring-tool edge, 10 – 100 % reflectance of the target, strong backlight and – 10 °C to +50 °C operating tem-
perature. Additionally, a deviation influence of ±0.29 mm/m must be taken into account.
D) For measurements with the rear side of the unit as reference, the max. measuring range is ±60°
E) After calibration at 0 ° and 90 ° with an additional grade error of ±0.01 °/degree to 45 ° (max.).
F) In the continuous measurement function, the maximum operating temperature is +40 °C.
G) At 25 °C operating temperature
H) For a new and charged battery without display illumination, Bluetooth® and tone signal.
I) For Bluetooth® low-energy-devices, establishing a connection may not be possible, depending on model and operating system. Bluetooth® devices
must support the SPP profile.
Please observe the article number on the type plate of your battery charger. The trade names of individual battery chargers may vary.
Please observe the article number on the type plate of your measuring tool. The trade names of the individual measuring tools may vary.
The measuring tool can be clearly identified with the serial number 20 on the type plate.
OBJ_BUCH-2007-002.book Page 10 Friday, January 24, 2014 10:46 AM
To Next Page
Loading...
