English | 11
Bosch Power Tools 2 609 141 167 | (15.4.14)
Switching On and Off
–To switch on the measuring tool and the laser, briefly press the measuring button
2.
–To switch on the measuring tool without the laser, briefly press the On/Off button
5.
Do not point the laser beam at persons or animals and do not look into the la-
ser beam yourself, not even from a large distance.
To switch off the measuring tool, press the On/Off button 5 for a few seconds.
The measured values in the memory are retained when you switch the tool off.
Measuring Procedure (see figure A)
Once switched on, the measuring tool is in the length measurement function. You can
set other measuring functions by repeatedly pressing button 4 (see “Measuring Func-
tions”, page 12).
The rear edge of the measuring tool is always the reference level for the measure-
ment.
Place the measuring tool against the desired starting point of the measurement (e.g.
a wall).
Note: If the measuring tool has been switched on using the On/Off button 5, briefly
press the measuring button 2 to switch the laser on.
Briefly press the measuring button 2 to initiate the measurement. Then the laser
beam is switched off. To switch the laser beam on again, briefly press the measuring
button 2. To initiate a further measurement, briefly press the measuring button 2
again.
Do not point the laser beam at persons or animals and do not look into the la-
ser beam yourself, not even from a large distance.
In the continuous measurement mode, the measurement begins immediately upon
switching on the function.
Note: The measured value typically appears within 0.5 seconds and no later than
4 seconds. The duration of the measurement depends on the distance, the lighting
conditions and the reflective properties of the target surface. Upon completion of the
measurement the laser beam is automatically switched off.
OBJ_BUCH-2181-001.book Page 11 Tuesday, April 15, 2014 10:12 AM
To Next Page
Loading...
