12 | English
2 609 141 167 | (15.4.14) Bosch Power Tools
Measuring Functions
Length Measurement
For length measurements, repeatedly press button 4 until the indicator for length
measurement appears on the display 1.
To measure, briefly press the measuring button 2.
The measured value will be shown at the bottom of the display.
Continuous Measurement (Tracking)
For continuous measurements, the measuring tool can be moved relative to the tar-
get, whereby the measuring value is updated approx. every 0.5 seconds. In this man-
ner, as an example, you can move a certain distance away from a wall, while the actual
distance can always be read.
For continuous measurements, repeatedly press button 4 until the indicator for con-
tinuous measurement appears on the display 1. The laser will be switched on and
measurement will begin immediately.
Move the measuring tool until the required distance value is indi-
cated in the bottom of the display.
Briefly press the measuring button 2 to end continuous meas-
urement. The last measured value will be shown at the bottom of
the display.
Continuous measurement automatically switches off after
5 min. The last measured value remains indicated at the bottom
on the display.
Area Measurement
For area measurements, repeatedly press button 4 until the indicator for area meas-
urement appears on the display 1.
Then measure the width and length one after the other as with a length measurement.
The first measured value will be shown at the bottom of the display. The laser beam
remains switched on between the two measurements.
OBJ_BUCH-2181-001.book Page 12 Tuesday, April 15, 2014 10:12 AM
To Next Page
Loading...
