14 | English
2 609 141 167 | (15.4.14) Bosch Power Tools
Memory Functions
Memory value display
The memory value display is only available when a length measurement has been per-
formed. Maximum 10 measured values can be retrieved.
To display memory values, repeatedly press button 4 until “M” appears on the display
1.
The number of the measured value is displayed after “M”, and
the respective measured value is displayed underneath.
Press button 6 to browse forwards through the saved measured
values.
Press button 3 to browse backwards through the saved meas-
ured values.
If no measured value is available in the memory, “0.000” is
shown in the bottom line of the display and “M 0” in the line
above.
Deleting the Memory
To delete the contents of the memory, first press button 4 so that “M” appears on the
display. Then briefly press the On/Off button 5 to delete the displayed measured val-
ue.
Adding/subtracting measured values (see figure B)
Measured values can be added or subtracted only in length measurement. A warning
signal will sound if you use it in other measuring functions.
To measure, briefly press the measuring button 2.
The measured value will be shown at the bottom of the display.
Press button 6 to add measured values or press button 3 to sub-
tract measured values. “+” or “–” will appear at the bottom of the
display. Take another measurement. The current measured val-
ue will be shown at the bottom of the display, and the previous
measured value will be shown above it.
OBJ_BUCH-2181-001.book Page 14 Tuesday, April 15, 2014 10:12 AM
To Next Page
Loading...
