40 | English
1 609 92A 23J | (25.8.16) Bosch Power Tools
Deleting the Memory
To delete the content of the memory, press button 7 [Func] and select the memory
function . Then briefly press the On/Off button 5 [ ] to delete the displayed value.
Simultaneously pressing the button 4 and the On/Off button 5 [ ] deletes all values
stored in the memory.
Adding/Subtracting Values
Measured values or end results can be added or subtracted.
Adding Values
The following example describes the addition of areas:
Measure an area as described in section “Area Measurement”, see page 36.
Press the button 3 [+]. The calculated area and the symbol “+” will be
displayed.
Press the measuring button 2 [ ] to start another area measurement.
Measure the area as described in section “Area Measurement”, see
page 36. Once the second measurement is completed, the result of the
second area measurement is displayed below.To show the end result,
press the measurement button 2 [ ] once more.
Note: With a length measurement, the end result is displayed immediately.
To exit addition, press button 7 [Func].
Subtracting Values
To subtract values, press button 8 [–]. The subsequent steps are the same as for
“Adding Values”.
Deleting Measured Values
Briefly pressing the On/Off button 5 [ ] will delete the last measured value in all
measuring functions. Repeated brief pressing of the On/Off button 5 [ ] will delete
the measured values in reverse order.
Changing the Unit of Measure
Unit of measure “m” (metres) is set by default.
Switch the measuring tool on.
Press and hold button 7 [Func], to enter the “basic configurations” menu. Select “ft/m”.
Press button 3 [+] or button 8 [–], to change the unit of measure.
Press the On/Off button 5 [ ] to exit the menu item. The selected setting remains
saved after you switch off the measuring tool.
To Next Page
Loading...
