English | 19
Bosch Power Tools 1 609 92A 3UB | (15.3.17)
Upon completion of the measurement, the result for the sought dis-
tance “X” is displayed in the result line e. The measuring values for the
distance “1” and the angle “α” are displayed in the measured-value
lines d.
Wall Surface Measurement (see figure E)
The wall surface measurement is used to determine the sum of several individual sur-
faces with a common height.
In the illustrated example, the total area of several walls should be determined, which
have the same ceiling height H, but different lengths L.
Select the wall surface measurement .
Measure the ceiling height H as with a length measurement. The measured value is
displayed in the top measured-value line. The laser remains switched on.
Then measure the length L
1
of the first wall. The surface is automatically
calculated and displayed in the result line e. The last length measured
value is in the bottom measured-value line d. The laser remains
switched on.
Now measure the length L
2
of the second wall.The individual measured
value displayed in the measured-value line d is added to the length L
1
.
The sum of the two lengths (displayed in the middle measured-value line d) is multi-
plied by the saved height H. The total surface value is displayed in the result line e.
You can measure any number of lengths L
X
, which will be automatically added and
multiplied by the height H.
The requirement for a correct area calculation is that the first measured length (for ex-
ample the ceiling height H) is identical for all sub-areas.
Stake out function (see figure F)
The stake out function repeatedly measures a defined length (distance). These
lengths can be transferred to a surface, for example to enable material to be cut into
pieces of equal lengths or to install stud walls in a drywall construction. The minimum
adjustable length is 0.1 m, the maximum adjustable length is 50 m.
Select the stake out function .
Set the desired length. Using button 7 [Func] select the corresponding digit/position
and change the value with button 3 [+] or button 8 [–].
Begin the stake out function by pressing the measuring button 2 [] and slowly
move away from the starting point.
6.412 m
0.0°
m6.457
60.0°
To Next Page
Loading...
