22 | English
1 609 92A 3UB | (15.3.17) Bosch Power Tools
Changing the Unit of Measure
Unit of measure “m” (metres) is set by default.
Switch the measuring tool on.
Press and hold the 7 [Func] button to enter the “basic configurations” menu. Select
“m/cm” (for 3 601 K72 C40 and 3 601 K72 C80) or “ft/m”(for 3 601 K72 C00).
Press button 3 [+] or button 8 [–], to change the unit of measure.
Press the On/Off button 5 [ ] to exit the menu item. The selected setting remains
saved after you switch off the measuring tool.
Bluetooth® Interface
Data Transmission to other Devices
The measuring tool is equipped with a Bluetooth® module, which enables data trans-
mission via radio technology to certain mobile terminals/devices with a Bluetooth® in-
terface (e.g., smartphones, tablets).
For information on the necessary system requirements for a Bluetooth® connection,
please refer to the Bosch website at
www.bosch-pt.com
For more information, visit the Bosch product page, see QR code, page 8.
For data transmission via Bluetooth®, time delays between mobile terminal/device
and measuring tool may occur. This can be possible due to the distance between both
devices or the object being measured.
Activating the Bluetooth® Interface for Data Transmission to a Mobile Terminal/
Device
To activate the Bluetooth® interface, press the Bluetooth® button 6 on the measuring
tool.To activate the Bluetooth® signal, press the Bluetooth® button 6 or the button
3 [+] once again. Ensure that the Bluetooth® interface is activated on your mobile ter-
minal/device.
To expand the functionality of the mobile terminal/device and to simplify the data pro-
cessing, special Bosch applications (apps) are available. These can be downloaded in
the respective stores, depending on the terminal/device.
The connection between mobile terminal/device and measuring tool is established af-
ter the Bosch application has started. If multiple active measuring tools are found, se-
lect the appropriate measuring tool using the serial number.
The connection status as well as the active connection (a) are displayed in the status
bar (h) of the measuring tool.
OBJ_BUCH-2548-004.book Page 22 Wednesday, March 15, 2017 12:57 PM
To Next Page
Loading...
