Bosch GLM 500 - 11.6.7.2 Deleting the memory; 11.7 Adding;subtracting values; 11.7.1 Adding values; 11.7.2 Subtracting values

430.16 m
8.890 m
3
7.620 m
m6.350
4
The number of the memory value is shown at the top of the display, the
corresponding memory value is shown at the bottom, and the corres-
ponding measuring function is shown on the left.
Press the [+] button (3) to browse forwards through the saved values.
Press the [–] button (8) to browse backwards through the saved val-
ues.
If there is no value available in the memory, 0.000 is shown at the bottom of the display
and 0 at the top.
The oldest value is located in position 1 in the memory, while the newest value is in posi-
tion 20 (when 20 memory values are available). When a further value is saved, it is al-
ways the oldest value in the memory that is deleted.
Deleting the memory
Press the memory button (6) [ ] to delete the contents of the memory. Then briefly
press the on/off button (5) [ ] to delete the displayed measured value.
To delete all values in the memory, press the button (4) and the on/off button (5) [ ] at
the same time, then release the on/off button (5) [ ].
Adding/subtracting values
Measured values or end results can be added or subtracted.
Adding values
The following example describes the addition of areas:
Measure an area as described in the section on area measurement (see "Area measure-
ment", page34).
143.45 m
2
2
+93.406
m50.039
0.0°
m
2
Press the [+] button (3). The calculated area and the + symbol will be
displayed.
Press the measuring button (2) [ ] to start another area measurement.
Measure the area as described in the section on area measurement (see
"Area measurement", page34). Once the second measurement is com-
pleted, the result of the second area measurement is displayed below.
To show the end result, press the measuring button (2) [ ] once more.
Note: In the case of a length measurement, the end result is displayed immediately.
To exit addition, press the [Func] button (7).
Subtracting values
To subtract values, press the button (8) [–]. The subsequent steps are the same as for
the section on adding values.
English | 37
Bosch Power Tools 1 609 92A 4RG | (15.11.2018)