Bosch GLM Professional 100-25 C - Inserting;Changing the Battery

30 | English
Digital laser measure GLM 100-25 C GLM 150-27 C
Max. transmission power 8mW 8mW
A) When measuring from the front edge of the measuring tool, this applies for high reflectivity of the
target (e.g. a wall painted white), weak background lighting and a 25°C operating temperature; a
distance-dependent deviation of ±0.05mm/m must additionally be factored in.
B) When measuring from the front edge of the measuring tool, this applies for high reflectivity of the
target (e.g. a wall painted white), strong background lighting, 25°C operating temperature and
large altitudes. In addition, a deviation of ±0.15mm/m must be taken into account, depending on
the distance.
C) In continuous measurement mode, the max. operating temperature is +40 °C.
D) Only non-conductive deposits occur, whereby occasional temporary conductivity caused by con-
densation is expected.
E) At an operating temperature of 25 °C. Charging time with 1A USB charger. Faster charging with
the measuring tool switched off.
F) For additional technical data, visit: https://www.bosch-professional.com/ecodesign
G) When using Bluetooth® Low Energy devices, it may not be possible to establish a connection de-
pending on the model and operating system. Bluetooth® tools must support the GATT profile.
The serial number (16) on the type plate is used to clearly identify your measuring tool.
Inserting/Changing the Battery
GLM 100-25 C
Press the release button(7) and swing out the stop pin(8) by 180°.
To open the battery compartment cover(17), flip the screw cap(25) up and turn it a
quarter rotation anticlockwise.
Lift the battery compartment cover(17) on the screw cap(25).
Insert the batteries or rechargeable batteries.
Always replace all the batteries/rechargeable batteries at the same time. Only use
batteries/rechargeable batteries from the same manufacturer and which have the
same capacity.
When inserting the batteries, ensure that the polarity is correct according to the il-
lustration on the inside of the battery compartment.
u Take the batteries out of the measuring tool when you are not using it for a pro-
longed period of time. The batteries can corrode and self-discharge during prolonged
storage.
1 609 92A 6UN | (21.09.2021) Bosch Power Tools