Bosch GLM Professional 150-27 C - Measuring Process

32 | English
You can also switch on the measuring tool without the laser by pressing the button.
Press and hold the button to switch off the measuring tool.
The measured values and device settings in the memory are retained.
Camera
Press the / button to switch the camera on or off.
The selected setting remains saved after you switch off the measuring tool.
For larger distances (approx.>5m), a target marking is additionally shown for marking
the measuring point.
For more information, you can access the online operating instructions at
www.bosch-pt.com/manuals
Measuring Process
Once switched on, the measuring tool is in the length measurement function.
Once the measuring tool has been switched on, the rear edge of the measuring tool is se-
lected as the reference level for measurement. You can change the reference level. (see
"Selecting the Reference Level", page33)
Apply the measuring tool to the point at which you want to start the measurement (e.g.
wall).
Press the button to start the measurement.
With a switched-on permanent laser beam and in the continuous measurement function,
the measurement begins immediately after the first press of the button.
The switched-on permanent laser beam is not switched off after the measurementPer-
manent Laser Beam.
For more information, you can access the online operating instructions at
www.bosch-pt.com/manuals
The measuring tool must not be moved during a measurement. Therefore, place the
measuring tool, as far as this is possible, against or on a firm stop or supporting sur-
face.
The reception lens(20), the laser beam output(21) and the camera(22) must not
be covered during the measuring process.
1 609 92A 6UN | (21.09.2021) Bosch Power Tools