-19-
Assembly
Inserting/Replacing the Batteries
Alkaline batteries (2 x 1,5 V LR6 (AA)) are recommend-
ed for the laser measure.
Press the locking mechanism (12) to open the battery
compartment cover (13) and remove the battery com-
partment cover. Insert the batteries. When inserting,
pay attention to the correct polarity according to the
representation on the inside of the battery compart-
ment.
When the empty battery symbol first appears on the
display, then approximately 100 measurements are
still possible. When the battery symbol is empty and
red flashing, measurements are no longer possible.
Replace the batteries.
Always replace all batteries at the same time. Only
use batteries from one brand and with identical ca-
pacity.
Remove the batteries from the laser measure when
not using it for extended periods. When storing for
extended periods, the batteries can corrode and dis-
charge themselves.
To Next Page
Loading...
