To Next PageTo Next Page
Need help?Do you have a question about the Bosch GSA 18V-32 Professional and is the answer not in the manual?
General| Power source | Battery |
|---|---|
| Battery voltage | 18 V |
| Battery capacity | 5 Ah |
| Vibration emission | 11.6 m/s² |
| Stroke rate (1st gear) | 0 spm |
| Stroke rate (2nd gear) | 2500 spm |
| Soft grip | Yes |
| Product color | Black, Blue |
| Stroke length | 32 mm |
| Cutting depth in wood | 230 mm |
| Cutting depth in metal profiles/pipes | 175 mm |
Weight and Dimensions| Depth | 482 mm |
|---|---|
| Width | 101 mm |
| Height | 218 mm |
| Weight | 3500 g |
Read all safety warnings and instructions. Failure to follow may result in shock, fire and/or injury.
Keep work area clean and well lit. Do not operate in explosive atmospheres. Keep children and bystanders away.
Ensure correct plugs and outlets. Avoid body contact with earthed surfaces. Do not expose to rain or wet conditions.
Stay alert, use common sense. Use personal protective equipment. Do not overreach. Dress properly.
Do not force the tool. Use correct tool for application. Do not use if switch is faulty. Disconnect power before adjustments.
Recharge only with specified charger. Use only designated battery packs. Risk of injury and fire.
Machine is intended for sawing wood, plastic, metal and building materials. Suitable for straight and curved cuts.
Numbering of components shown refers to graphic pages. Lists numbered parts of the tool.
Use only specified chargers. Charge battery fully before first use. ECP protects against deep discharge.
Press unlocking button 16 and pull battery rearward. Do not exert force.
Three green LEDs indicate charge condition. Press button 12 to check status. Defective battery has no LEDs lit.
Use suitable blades for material. Use only ½" universal shank blades. Ensure blade is not longer than required.
Swing lever 4, slide blade 1 into holder 18, release lever. Check seating.
Insert charged battery. Control/preset stroke rate using switch 8 and thumbwheel 7.
Adjustable orbital action adapts cutting speed to material. Set with rotary switch 6.
For thin or hard material. For achieving clean cutting edges.
For non-ferrous metals, hardwood, plastics, medium density materials.
For non-ferrous metals, hardwood, plastics, medium density materials.
Adjustable footplate adapts to surface angle. Can be moved in lengthway direction in three steps.
Press lock-off button 9, then press On/Off switch 8 to turn on. Release switch 8 to turn off.
Remove battery before maintenance. Keep machine clean. Ensure saw blade is longer than workpiece diameter.
Swing lever 4, pull blade 1 out of holder 18, release lever.
Suitable for soft materials only. Use blades max 100mm. Plunge slowly into workpiece.
Use elastic bimetal blades. Saw off flush at the wall with lateral pressure.
Hook for hanging tool. Fold out hook and ensure saw blade is protected.
Use coolant/lubricant when sawing metal due to material heating.
Clean saw blade holder with compressed air or brush. Apply suitable lubricant to holder.
Contact service for repair, spare parts. Find exploded views online. Include article number in correspondence.
Observe transport instructions. Li-Ion batteries must be handled according to specific regulations.
