14
BA 2 609 931 399
Stroke Rate Selection/Constant
Electronics with Soft Start
(GST 100 CE)
With the thumbwheel
1
, the required stroke rate
can be selected (also while running).
1 - 2 = Low stroke rate
3 - 4 = Medium stroke rate
5 - 6 = High stroke rate
The built-in soft start electronics prevent a jerking
“Run-up” when the machine is switched on.
After the brief soft run-up, the machine is regu-
lated to the preselected stroke rate.
The Constant Electronics with
“Tach-generator” keeps the prese-
lected stroke rate nearly constant
also under load.
The stroke rate required depends upon the mate-
rial and the working conditions. The optimal set-
ting can be determined in practice. You can find
relevant information in the following table.
After working for longer periods at low stroke rate
allow the machine to cool by running it at maxi-
mum stroke rate and no load for approx. 3 min-
utes.
The contact protector
3
attached to the machine
prevents unintentional contact with the saw blade
while working.
Dust extraction prevents large ac-
cumulations of dust, high concen-
trations of dust in the ambient air
and facilitates disposal.
For long periods of working with
wood or for commercial use on ma-
terials that produce dust that is det-
rimental to health, the machine is to
be connected to a suitable
external
dust extraction
device.
Vacuuming Connector Piece
The vacuuming connector piece
14
serves for the
connecting of a suitable vacuum hose.
When inserting the connection piece
14
into the
base plate
11
, take care that the plastic nose of
the vacuuming adapter engages in the corre-
sponding hole on the motor housing (see Figure).
For vacuuming, a Bosch 19 mm dia. vacuum
hose
15
can be directly connected to the connec-
tor piece
14
. The use of a 35 mm dia. vacuum
hose requires that an additional adapter be use
(
1 600 499 005
- see accessories).
The machine can be connected directly to the
socket of a Bosch all-purpose vacuum cleaner
with a remote starting device. The vacuum
cleaner is started automatically when the ma-
chine is switched on.
So that optimum vacuuming of the sawdust is en-
sured, the vacuum channels and the vacuuming
adapter should be cleaned regularly.
Dust Cover
The transparent dust cover
2
makes possible the
collecting of the sawdust and must always be
mounted when dust vacuuming is used.
Mounting:
Place the cover from the front onto
the contact protector
3
and snap on.
Removal:
Take hold of the cover at the sides,
tilt slightly and pull off to the front.
Contact Protector
Dust Vacuuming with the
External Extractor Device
1
GST 100/CE - GB Seite 14 Donnerstag, 11. März 1999 8:35 08
To Next Page
Loading...
