Bosch GWS Professional 24-230 VX - Page 18

English | 19
Bosch Power Tools 1 619 929 J27 | (15.9.11)
When cutting in stone, provide for sufficient dust extraction.
With approved sanding tools, the machine can be used for
sanding with sanding discs.
Product Features
The numbering of the product features refers to the illustra-
tion of the machine on the graphics page.
1 Spindle lock button
2 Vibration damper
3 On/Off switch
4 Auxiliary handle (insulated gripping surface)
5 Grinder spindle
6 Protection guard for grinding
7 Encoding key
8 Clamping lever for protection guard
9 Screw for adjustment of protection guard
10 Mounting flange with O-ring
11 Grinding disc*
12 Clamping nut
13 Quick-clamping nut *
14 Carbide grinding head*
15 Protection guard for cutting*
16 Cutting disc*
17 Hand guard*
18 Spacer discs*
19 Rubber sanding plate*
20 Sanding sheet*
21 Round nut*
22 Cup brush*
23 Cutting guide with dust extraction protection guard *
24 Diamond cutting disc*
25 Handle (insulated gripping surface)
*Accessories shown or described are not part of the standard de-
livery scope of the product. A complete overview of accessories
can be found in our accessories program.
Technical Data
Noise/Vibration Information
Measured sound values determined according to EN 60745.
Typically the A-weighted noise levels of the product are: Sound pressure level 91 dB(A); Sound power level 102 dB(A). Uncer-
tainty K =3 dB.
Wear hearing protection!
Angle Grinder GWS ...
Professional
24-230
VX
24-230
JVX
24-230
JVX
26-180
JBV
26-230
BV
26-230
JBV
Article number
3 601 ... H64 S.. H64 Z..
H64 5..
H64 U.. H55 U.. H56 S.. H56 U..
Rated power input W 2400 2400 2400 2600 2600 2600
Output power
W 1600 1600 1600 1700 1700 1700
Rated speed
min
-1
6500 6500 6500 8500 6500 6500
Grinding disc diameter, max.
mm 230 230 230 180 230 230
Thread of grinder spindle
M 14 M 14 M 14 M 14 M 14 M 14
Thread length (max.) of grinder spindle
mm 18 18 18 25 25 25
Restarting Protection
– – z z – z
Reduced starting current
– zzz – z
Rotatable main handle
z zzzzz
Run-on Brake
z zz –––
Weight according to EPTA-Procedure
01/2003 kg 6.5 6.5 6.6 6.2 6.4 6.4
Protection class
/II /II /II /II /II /II
The values given are valid for a nominal voltage [U] of 230 V. For different voltages and models for specific countries, these values can vary.
Please observe the article number on the type plate of your machine. The trade names of the individual machines may vary.
Only for power tools without reduced starting current: Starting cycles generate brief voltage drops. Interference with other equipment/machines may
occur in case of unfavourable mains system conditions. Malfunctions are not to be expected for system impedances below 0.25 ohm.
OBJ_DOKU-27975-001.fm Page 19 Thursday, September 15, 2011 8:31 AM