38/68 Installation
Bosch Rexroth Mellansel AB, Installation and maintenance manual , Hägglunds CB, RE 15302-WA/05.2019
Fig. 33: Mounting of shrink disc to adapter shaft or coupling motor
DD00100620DD00100402
Fig. 34: Shrink disk
*) Dashed line =
Lubricated
surface
Coupling ring
Clamping rings
Washer
Seal
Cleaned surface - no lubrication
Hollow shaft
Centre of shaft
DD00058194
*) The conical surface between the coupling ring and the clamping rings as well as the
screws shall be coated with Molykote G-Rapid plus paste, (see Fig. 34). This is done
from the factory at delivery.
When a motor has been in for overhaul or service and shall be reassembled it may
be necessary to relubricate those surfaces with Molykote G-Rapid plus paste again
but only on the specified surfaces.
To Next Page
Loading...
