Bosch HII8047C - 8.14.3 Automatic panel lock; 8.15 Wipe protection; 8.15.1 Activating the wipe protection; 8.15.2 Deactivating the wipe protection

en-us Cooktop operation
34
Automatic panel lock
This function automatically activates the panel lock when
you switch off the cooktop.
The automatic panel lock can be activated in the basic
settings → Page34 .
8.15 Wipe protection
With this function you can avoid changing the settings
while cleaning the control panel during cooking.
This function does not lock the main switch. You can turn
the cooktop off at any time.
Activating the wipe protection
▶ Press panel lock/Panel Lock.
a The indicator above the panel lock key lights up.
a The control panel is locked for 35seconds.
a After 30seconds a beep indicates that the wipe
protection is about to turn off.
Deactivating the wipe protection
▶ Press panel lock/Panel Lock.
a The indicator above the panel lock key goes out.
8.16 Basic settings
You can configure the basic settings for your appliance to
meet your needs.
Basic settings overview
Here you can find an overview of the basic settings and
the preset factory settings.
Display Function
Panel lock
– Manual
1
– Automatic
– Function deactivated
Signal tones
– Confirmation signal and error signal are
off. The main switch signal remains on.
– Only error signal is on.
– Only confirmation signal is on.
– Confirmation signal and error signal are
on
1
.
Display energy consumption
– Deactivated
1
– Activated
Duration of timer end signal
– 10seconds
1
– 30seconds
– 1minute
⁠ ⁠ Power management function. Limiting the
total power of the cooktop. The available
settings depend on the maximum power of
the cooktop.
1
Factory setting
2
Factory setting (may vary according to model)
Display Function
– Deactivated
2
,
– 1.000W minimum power
– 1.500W
...
– 3.000W recommended for 13A
. – 3.500W recommended for 16A
– 4.000W
. – 4.500W recommended for 20A
...
or . – Maximum power of the cooktop
Changing the preset power levels for
PowerMove®
- Preset power level for the front cooking
zone.
- Preset power level for the middle
cooking zone.
- Preset power level for the rear cooking
zone.
Results for suitability test for cookware
– Not suitable.
– Not ideal.
–Suitable.
Configuring status of FlexInduction™ cooking
zone when the cooktop is turned on
– As two independent cooking zones
2
– As a joined cooking zone.
Restore factory settings
– Off
1
– Restore appliance to factory settings
1
Factory setting
2
Factory setting (may vary according to model)
Changing the basic settings
Requirement:The cooktop is turned off.
1. Turn on the cooktop.
2. Within the next 10seconds, press kitchen timer/Timer
for about 4seconds.
The first four displays provide the product information.
To call up the individual displays, touch the control
panel.
Product information Display
Customer Support index (CI)
Production number
Production number1
Production number2 ⁠.
3. Press kitchen timer/Timer to enter the basic settings
menu.
a In the left display and flash alternately.
a In the timer display lights up.
4. Press kitchen timer/Timer repeatedly until the desired
setting lights up in the left display.
5. Set the desired option in the settings area.