Bosch HII8057C - General Tips for Heating Modes

en-us Oven operation
22
7.5 Meat probe
The meat probe measures the internal temperature of the
food. You can set a core temperature and the heating
mode turns off automatically as soon as the set
temperature is reached.
WARNING
Use of a wrong meat probe can damage the insulation.
▶ Use only the meat probe intended for this appliance.
The meat probe can be used with the following heating
modes:
¡ Bake
¡ Roast
¡ Conv Bake
¡ Conv Multi-Rack
¡ Conv Roast
¡ The probe function is not available when an oven timer
has been set.
¡ The meat probe measures the temperature on the
inside of the food between 85°F (30°C) and 210°F
(99°C).
¡ To prevent the meat probe from being damaged, do not
set an oven temperature above 480°F (250°C).
¡ Use only the meat probe supplied with your appliance.
Additional or replacement meat probes can be ordered
from Customer Service
¡ Do not store the probe in the oven cavity.
Inserting the meat probe
Requirements
¡ Food must be completely thawed before inserting the
probe into the meat.
¡ The probe ships with a black plastic safety cap over the
pointed metal end of the probe. The cap must be
removed prior to use.
1. Insert the tip of the probe in the middle and thickest part
of the meat or the breast for poultry. Make sure the
probe is not touching fat, bone or parts of the oven or
the pan.
Always use the handle of the probe for inserting and
removing.
Note:The handle of the probe becomes hot during
cooking. Always use oven mitts when touching the
probe handle.
2. Insert the plug of the probe into the socket at the side of
the oven cavity.
Push the probe in all the way and pull back until it
catches in the socket.
Setting the meat probe
Requirement:→ "Inserting the meat probe", Page22
1. Set the desired heating mode and temperature.
2. Press Probe.
a and "SET PROBE TEMP" is displayed.
a A three digit input prompt "- - -" blinks on the display.
3. Set the desired core temperature with the numeric
keypad.
4. Press Enter.
a The current and target temperature of the probe are
displayed.
a When the set probe temperature is reached, the heating
mode turns off. "COOKING COMPLETE" blinks in the
display. An alarm tone sounds every 10seconds for
2minutes.
5. Press Oven Clear/Off or remove the probe to turn off
the display.
– Always use the handle of the probe for inserting and
removing.
– The probe becomes hot during use. Always use
potholders to remove the probe.
a The display goes to standby mode.
7.6 Turning the panel lock on or off
With the panel lock you can disable all touch keys on the
control panel.
Requirement:The oven is in standby mode.
1. Press and hold Panel Lock for 3seconds.
2. Press and hold Panel Lock again for 3seconds to turn
off the panel lock.
a The display returns to standby mode.
7.7 Kitchen timer
The kitchen timer is a countdown timer that has no affect
on oven heating.
You can set a kitchen timer value up to 99:59 hours.
Setting the kitchen timer
1. Press Kitchen Timer.
a 0:00 blinks in the display.
2. Enter the desired timer value in H/MM format using the
numeric keypad.
3. Press Enter.
a The timer starts to count down.
a When the kitchen timer has counted down an alarm
tone sounds for 2minutes.
a Press Kitchen Timer to cancel the timer or to turn off
the alarm tone.
Editing the kitchen timer
1. Press Kitchen Timer.
a The current timer value blinks and can be edited.
2. Enter the desired timer value using the numeric keypad.
3. Press Enter.