58300000187895 ARA EN A MAY 2015 Service Manual for Bosch Benchmark Series Induction Slide-in Ranges
Page 12 of 36
Copyright by BSH Home Appliances Corporation 1901 Main St ▪ Suite 600 ▪ Irvine, CA 92614 800 944-2904
This material is intended for the sole use of BSH authorized persons and may contain confidential and proprietary information. Any unauthorized review, use, copying, disclosure, or distribution in any format is prohibited.
6 WARMING DRAWER OPERATION
The 120VAC warming drawer temperature is regulated using a basic
2-point control algorithm. When set, the element is on 100% until the
cavity temperature reaches 34°F / 1°C above set point. The element
is then turned off until cavity temperature is 34°F / 1°C below set
point.
There are three temperature settings: LOW (115°F / 46°C), MED
(127°F / 53°C), and HIGH (144°F / 62°C). When the Warming Drawer
key is pressed, MED (default temperature) will be displayed. To
accept this setting, the Enter key may be pressed, or alternatively, the
Warming Drawer key may be pressed again to cycle through the
temperature settings.
The warming drawer requires two key inputs to start heating. If the
Warming Drawer key is pressed (one key), and is not followed within
five seconds by either an Enter key press or subsequent Warming
Drawer key press to change the temperature setting, the display will
clear and the drawer will not start heating.
Pressing the Warming Drawer key while it is operating immediately
deactivates the mode.
The element is 120V 400W.
To Next Page
Loading...
