58300000187895 ARA EN A MAY 2015 Service Manual for Bosch Benchmark Series Induction Slide-in Ranges
Page 25 of 36
Copyright by BSH Home Appliances Corporation 1901 Main St ▪ Suite 600 ▪ Irvine, CA 92614 800 944-2904
This material is intended for the sole use of BSH authorized persons and may contain confidential and proprietary information. Any unauthorized review, use, copying, disclosure, or distribution in any format is prohibited.
Figure 28 Removing the RH hinge receiver
8. Secure the new fan to the fan mounting bracket, attach the
wires and reassemble.
9. Restore power to the unit and test operation.
10. Reinstall housing cover(s).
11. Slide the range back into the cutout, being sure to engage the
anti-tip bracket.
7.12 Hinge Receivers
To replace the hinge receivers, the range must be pulled out of
the cutout to provide access to the side panel(s).
7.12.1 Replacing the Hinge Receivers
1. Remove power to the range.
2. Remove the oven door (see Removing and Reinstalling the
Door).
3. Carefully slide the range out of the cutout to gain access to the
side panels.
4. Remove the finished side wall panel.
5. Remove the inner side wall bracket.
6. Remove the side housing cover.
7. From the front of the range, remove the two screws securing
the hinge receiver to the range.
8. Pull back the side insulation to reveal the hinge receiver and
remove the part.
9. Install the new hinge receiver.
10. Reinstall the oven door and test door operation.
11. Reinstall the side housing cover, the side wall bracket and the
finished side wall panel.
12. Restore power, and test operation.
13. Slide the range back into the cutout, being sure to engage the
anti-tip bracket.
To Next Page
Loading...
