Easy Series (ICP-EZM2) | Installer Guide | 4.0 Programming
36 Bosch Security Systems, Inc. | 5/07 | F01U025147-01
4.3 Expert Programming
Only use expert programming if you have a special programming requirement.
To comply with specific agency requirements, refer to Section 7.7 Agency Approvals and
Requirements on page 68 for any necessary programming changes.
Expert programming allows access to all programming categories for full system configuration:
• System
• Communicator
• Report routing
• Points
• Outputs
• Control centers
• Users
Each category consists of several related programming items. Each programming item is assigned a three- or
four-digit number.
Installer
Phone
Menu
Installer passcode
4-digit default: 5432
6-digit default: 543211
Programming
Key
Custom
Messages
Two-Way
Voice Session
Expert
Programming
Basic
Programming
User Menu
System
Maintenance
Exit installer menu and end phone session.
4
5
6
7
#
1
3
2
1. Enter an expert programming item number.
For example, 201, Phone Line Supervision.
2. Enter the desired value using your phone’s keypad.
For example, press [1] to enable phone line supervision.
3. Repeat Steps 1 and 2 to configure other programming items, or press [#] to exit
Expert Programming.
To Next Page
Loading...
