Bosch ICP-EZM2 - User Programming Items; Factory Default; Exit Programming

Easy Series (ICP-EZM2) | Installer Guide | 4.0 Programming
.
Bosch Security Systems, Inc. | 5/07 | F01U025147-01 53
Individual Control Center Items
These programming items are set independently for each control center connected to the control panel.
Programming
Item
Item Number Description Entry
Control Center 1: 811
Control Center 1: 5
Control Center 2: 821
Control Center 2: 5
Control Center 3: 831
Control Center 3: 5
Control Center
Brightness
Control Center 4: 841
5 = Brightest display (1 to 5)
Control Center 4: 5
Control Center 1: 814
Control Center 1:
0
Control Center 2: 824
Control Center 2:
0
Control Center 3: 834
Control Center 3:
0
Control Center
Backlight
Extinguish Mode
Control Center 4: 844
0 = Display is always on
1 = Display is dim until presence is
detected or button is pressed
2 = Display is off until presence is
detected or button is pressed
3 = Display is off until a valid token is
presented or passcode is entered
Control Center 4:
0
Default
= Country-specific default. Select this programming item to hear the updated default value.
4.3.8 User Programming Items
Programming Item
Item
Number
Description (Range) Entry
Passcode Length
861
Set the length of all passcodes
(4 or 6 digits).
4
Installer Passcode
(User 0)
7001
Four-digit Range: 1111 to 5555
Six-digit Range: 111111 to 555555
5432
543211
Master User
Passcode (User 1)
7011
Four-digit Range: 1111 to 5555
Six-digit Range: 111111 to 555555
1234
123455
Duress User
(User 22) Enabled
862
0 = Duress user disabled
1 = Duress user enabled
Duress User passcode:
Six digits: 111111
Four digits: 1111
0
RFID Token
Password
863
Use this item to prevent unauthorized copying of tokens
(00000000 to FFFFFFFF).
Do not change this item once tokens
are added to the system.
12345678
Default = Country-specific default. Select this programming item to hear the updated default value.
4.3.9 Factory Default
Programming Item Item Number Description
Factory Default
9999
Enter 9999 to restore all factory default values. All programming items, except
for the country code, are reset when you restore the factory default values.
This item also deletes all wireless data, but does not default the wireless hub.
4.4 Exit Programming
Press [#] repeatedly until the system says “goodbye.” This ends the phone session.