EasyManua.ls Logo

Bosch ICP-EZM2 - Specifications

Bosch ICP-EZM2
80 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Easy Series (ICP-EZM2) | Installer Guide | 7.0 Reference Materials
74 Bosch Security Systems, Inc. | 5/07 | F01U025147-01
7.8 Specifications
Enclosure
Dimensions (H x W x D): 37 cm x 31.8 cm x 8.5 cm (14.5 in. x 12.5 in. x 3.4 in.)
Construction Material: Cold-rolled steel, zinc seal, 0.36 mm thick (20 Ga.)
Environmental Considerations
Relative Humidity:
93% at 32°C ± 2°C (+90°F ± 2°F)
Operating Temperature: -10°C to +49°C (+14°F to +120°F)
UL: 0°C to +49°C (+32°F to +120°F)
CE: -10°C to +40°C (+14°F to +104°F)
Storage Temperature: -10°C to +55°C (+14°F to +130°F)
Supervised Points
On-board Hardwire: 8
Single or dual end-of-line (EOL) tamper point support
Point 1 supports two-wire smoke detectors
All points support four-wire smoke detectors
Enclosure tamper input (does not reduce point capacity)
Programmable Outputs (PO)
On-board: 4
PO 1 only: Configurable relay
PO 2 to PO 4: Configurable solid state
PO 4 only: Internal supervised speaker driver option
PO 1 Relay Rating:
Contacts: 2 A with no jumper installed; resistive loads only
Output: 1.2 A with jumper installed; resistive loads only
Operating Voltage: 30 VDC maximum
PO 2 to PO 4 Rating: 400 mA current sink
Control Center
Dimensions (H x W x D): 12 cm x 17.7 cm x 2.5 cm (4.7 in. x 7 in. x 1 in.)
Total Number Supported: 4
Recommended Mounting Surface: Non-metallic surface
Minimum Mounting Distance: 1.2 m (4 ft) between each control center
Current Draw: 110 mA standby; 165 mA alarm
Minimum Wire Length: 3 m (10 ft)
Maximum Wire Length:
Total: 400 m (1312 ft) using using 0.8 mm (#22 AWG) wire;
Single run: 100 m (328 ft) using 0.8 mm (#22 AWG) wire
Data Bus Wire Type Options:
1 four-conductor, power-limited 1.2 mm (#18 AWG) or 0.8 mm (#22 AWG)
wire
At least 0.6 mm (#24 AWG) twisted pair CAT5 wire
UL installations require power-limited wiring.
Audio Bus Wire Type Options:
1 two-conductor or 1 four-conductor, power-limited 1.2 mm (#18 AWG) or 0.8
mm (#22 AWG) wire. Only two conductors are used.
At least 0.6 mm (#24 AWG) twisted pair CAT5 wire
UL installations require power-limited wiring.
Unless using CAT5 cable, audio bus connections require a dedicated wire.
CAT5 Wire Requirements: Refer to Section 2.3 Control Center Installation on page 10.
Number of...
Users: 22
User 1: Master user
Users 2 to 21: System users
User 22: Duress user
Events: 500 history events, stamped with time and date
Tokens and Key Fobs: One per user (User 22 does not receive a token or key fob)

Table of Contents

Other manuals for Bosch ICP-EZM2

Related product manuals