Bosch ICP-EZM2 - Configure the B426

RPS device type RADION transmitter Wireless alarm inputs
Mini-Door-Window contact Door/window contact (RFDW-
SM)
Magnetic
CO detector CO detector (RFCO)* CO detector
* Future sensors that are not ready for testing at the time this document was published.
Notice!
Do not use any other RPS device types when specifying RADION transmitter configurations.
The columns labeled “Wireless Sensor Sensitivity” and “External Power Input” have no effect
on the Radion Wireless Receiver/Transmitter configuration. These fields are not used by the
Easy Panel Radion configuration.
The wireless repeater is the only RADION transmitter that supports an external AC power
supply. The RADION wireless repeater reports a trouble if a problem is discovered with the AC
Power.
Configure the B426
When installing under the following conditions, the B426 needs no further configuration:
– DHCP is available on your network.
– AES encryption is not required.
– Default B426 port settings (UDP on Port 7700) are permitted by the network
administrator.
For installations requiring non-default configuration, use the B426 web-based configuration
pages.
Refer to the B426 Installation and Operation Guide for details.
3.8
Easy Series Control Panel System Installation and Configuration | en 37
Bosch Security Systems, Inc. System Reference Guide 2014.09 | 01 | F.01U.306.221