Bosch ICP-EZM2 - Page 55

Programming Item Item
Numbe
r
Manuf.
Default
Programming Item Item
Numbe
r
Manuf.
Default
Intrusion Alarm Unverified 309 3 24-Hour Trouble Restoral 332 3
Intrusion Alarm 24-hr 310 3 Point Missing 333 3
Intrusion Alarm 24-hr Restoral 311 Point Missing Restoral 334 3
Intrusion Alarm Restoral 312 3 Supervisory Alarm 335 3
Duress 313 3 Supervisory Alarm Restoral 336 3
Fire Alarm 315 3 Wireless Point Low Battery 360 3
Fire Alarm Unverified 316 3 Wireless Point Low Battery Restoral 361 3
Fire Alarm Restoral 317 3 Fire Cancel 371 3
Panic 318 3 Point Tamper 388 3
Cancel 323 3 Point Tamper Restoral 397 3
Intrusion Trouble 324 3 Cross Zone Trouble 393 3
Intrusion Trouble Restoral 325 3 Alarm Recent Close 394 3
Intrusion Zone Bypass 326 3 Panic Restoral 399 3
Intrusion Zone Bypass Restoral 327 3 Cross Zone Trouble Restoral 400 3
*Enter a value to globally set all of the following reports to the same value.
To modify one a specific report, enter a value in that report’s item number:
0 = Neither route
1 = Route 1 only; Primary and Backup
2 = Route 2 only; Primary and Backup
3 = Both routes; Primary and Backup
System On and Off Report Routing
Programming Item Item
Number
Manuf.
Default
Programming Item Item
Numbe
r
Manuf.
Default
System On and Off*
(open and close) Reports (all)
302 3 Open 341 3
Exit Error 314 3 Open Keyswitch 342 3
Recent Closing 330 3 Open Remote 343 3
Close (System On) Unoccupied 337 3 Close (System On) Custom 344 3
Close (System On) Occupied 338 3 Opening by Guard Code 386 3
Close Keyswitch 339 3 Partial Close (System On) 403 3
Easy Series Control Panel Programming | en 55
Bosch Security Systems, Inc. System Reference Guide 2014.09 | 01 | F.01U.306.221