Factory Default
Programming Item Item
Number
Selections
Factory Default 9999 Enter 9999 to restore all factory default values. All programming items,
except for the country code, are reset when you restore the factory
default values. This item also deletes all wireless data.
Warning!
For NF A2P installations, once the control panel is configured, check that all parameters are
within the range of authorized values. Refer to EN50131 Requirements, page 11.
Exit Programming
Press [#] repeatedly until the system says "goodbye." This ends the phone session.
5.2.10
5.3
62 en | Programming Easy Series Control Panel
2014.09 | 01 | F.01U.306.221 System Reference Guide Bosch Security Systems, Inc.
To Next Page
Loading...
