Bosch ICP-EZM2 - Installation Considerations

Device testing To ensure proper functionality, the device must be
tested at least once every year.
Temperature (operating) 0ﾟC to +49ﾟC (+32ﾟF to +120ﾟF)
Relative humidity 0% to 93% (non-condensing)
Wall tamper switch Transmits a tamper signal when someone removes the
device from its base or pulls it away from the wall.
Frequency 433.42 MHz
Table 8.16: Specifications
Dual EOL Resistor Option
Use a 2.2 kￚΩ and 1.5 kￚΩ EOL resistor. Refer to the following figure.
1
3
4
2
5
Figure 8.10: Dual EOL resistor options
1 ￚ Normally-closed (NC) alarm
2 ￚ Normally-closed (NC) tamper
3 ￚ 1.5 k Ω alarm EOL
4 ￚ 2.2 k Ω tamper EOL
Notice!
To disable the alarm input, insert the EOL resistor directly into the inertia terminal block,
minus wiring to external devices.
Installation considerations
You have a variety of installation options to consider when installing the device. You must
acknowledge the unique installation approach prior to installation. Some installation
considerations include:
– Suitable surfaces for installation include wood, steel, and aluminum.
8.16.1
98 en | Device Specifications and Overview Easy Series Control Panel
2014.09 | 01 | F.01U.306.221 System Reference Guide Bosch Security Systems, Inc.