Bosch ICP-SOL3-P - 4.1.8 Parameter Menu

14 en | Operating Commands Control Panel
2014.06 | 02 | F01U298027 Quick Reference Guide Bosch Security Systems, Inc.
3. Only use auto-learn mode to configure keyfob RFID. Press [#] key to switch into auto-
learn mode. When icon numbers (1 to 16) flash, press button 1 or 2 of the keyfob. The
panel learns the WE800EV2 Keyfob ID number and the last digit of RFID number displays
on the codepad. Press [#] key to confirm.
4. Enter [#] key to confirm the operation, or press [*] to cancel.
Delete WE800EV2 Keyfob
1. Enter the Master Code, followed by [1] and the [#] key.
2. Enter the WE800EV2 keyfob number (301 to 321) you want to delete, followed by the [#]
key.
3. Press the [*] key to delete the WE800EV2 Keyfob.
Add RADION Keyfob
Set RF receiver as RADION Receiver.
1. Enter the Master Code, followed by [1] and the [#] key (for example, [12341#]).
2. Enter the RADION keyfob number (301 to 332) you want to add, followed by the [#] key.
Only current keyfob number (1 to 16 ) displays on the ICON codepad.
3. Use manual mode or auto-learn mode to configure RADION keyfob RFID.
– In manual mode, enter the 9-digit RF device ID number, followed by the [#] key.
– Or press [#] key to switch into auto-learn mode. When icon numbers (1 to 16) flash,
press button 1 or 2 of the keyfob. The panel learns the RADION Keyfob ID number
and the last digit of RFID number displays on the codepad. Press [#] key to confirm.
4. Enter [#] key to confirm the operation, or press [*] to cancel.
Delete RADION Keyfob
1. Enter the Master Code, followed by [1] and the [#] key.
2. Enter the RADION keyfob number (301 to 332) you want to delete, followed by the [#]
key.
3. Press the [*] key to delete the RADION Keyfob.
Set First Test Report
1. Enter the Installer Code, followed by [1] and the [#] key.
2. Enter the Number of Days (0 to 15) until the first test report is sent, followed by the [#]
key.
Change Domestic Telephone Numbers
Set up receiver transmission format as Domestic.
1. Enter the Installer Code or Master Code, followed by [2] and the [#] key.
2. Enter the telephone number, followed by the [#] key.
3. Enter the digits for the telephone number, followed by the [#] key.
If there is more than one telephone number, repeat Step 2 to Step 4.
Change the Telco Arm/Disarm Sequence
Telco Arm Sequency (Call Forward On)
1. Enter the Installer Code or Master Code followed by [3] and the [#] key.
2. Press [1] followed by the [#] key.
3. Enter the Call Forward On sequence.
4. Press the [#] key to exit.
Telco Disarm Sequency (Call Forward Off)
1. Enter the Installer Code or Master Code followed by [3] and the [#] key.
2. Press [2] followed by the [#] key.
3. Enter the Call Forward Off sequence.
4. Press the [#] key to exit.
3.4
3.5
3.6