Bosch Intellic EFAS-4.10 - Configuring General Settings for EFAS Tachograph; Adjusting the EFAS Tachograph Clock; Setting the Date and Time on EFAS

25
Workshop Manual
Smart Tachograph EFAS-4.10/4.11
6.4.1.3 Initial Installation
After activation, a full calibration must
be performed (see Chapter 9). After
removing the workshop card, the
printout “Technical Data” contains a
data set with the calibration purpose (2)
“Initial installation”. With the exception
of the number plate (incl. state), all
calibration parameters must be entered.
- Vehicle identication number
- Calibration purpose (2) „Initial calibration“
Note The ocial number plate can also be entered before activation.