Bosch Intellic EFAS-4.10 - National and European Time Zones Reference; National;Regional Abbreviations and Time Zones Table

57
Workshop Manual
Smart Tachograph EFAS-4.10/4.11
SrvID
hex
EFT
hex
DTC Symbol
Display text
Description and trouble-shooting
S7 01 40 00 000200
!  Card
invalid

(Symbol in the display for
invalid cards)
Meaning / Cause:
An invalid card has been inserted in the card slot 1.
The following causes are possible:
y The card has been inserted the wrong way round.
y The card is not a tachograph card.
y The tachograph card is defective.
y The PIN of a workshop smart-card has been entered incor-
rectly 5 times.
y The card reader is defective.
Checks take place when inserting the card and periodically
during operation.
Note:
Invalid tachograph smart-cards are ignored by EFAS, however
the display, printout, or downloading of data stored on expired
smart-cards is possible. An invalid or expired tachograph card is
reported by EFAS with the help of a symbol. Invalid cards are not
ejected automatically.
Measures:
Press key u to eject the card and check the card in accordance
with the measures listed above.
In order to check whether the card reader of the EFAS or the
card is defective, please check the card in another tachograph
or using a reader, or insert other tachograph cards (which are
known to be working properly) for comparison in the EFAS (see
also service ID S39/S40)
S8 01 40 00 000300
!  Card
invalid
This error matches the previous one, however, for card slot 2.
S9 03 40 00 000200
! Time
overlap
Meaning / Cause:
The tachograph card in card slot 1 contains an ejection time that
is later than the current time in EFAS. The event is usually only
possible if the card has been inserted into another tachograph
previously.
Measures:
y Check if the time setting deviates from the UTC time. If
possible, also check the time of the previous tachograph,
whether the time on this device deviates from the UTC time.
y Correct the UTC time using a workshop smart-card and an
appropriate diagnostics device.
S10 03 40 00 000300
! Time
overlap
This error matches the previous one, however, for card slot 2.
S11 05 40 00 000200
! Card inserted
whilst driving
Meaning / Cause:
A tachograph card has been inserted in card slot 1 whilst the
vehicle was in motion, i.e. motion sensor pulses were detected
and EFAS is in the “driving” mode.
Measures:
Insert the cards into the slots only when the vehicle is stationary.
S12 05 40 00 000300
! Card inserted
whilst driving
This error matches the previous one, however, for card slot 2.