Bosch Intellic EFAS-4.11 - Drivers Times Summary (iCounter)

77
Workshop Manual
Smart Tachograph EFAS-4.10/4.11
No. DTC
(hexadecimal)
Meaning Service ID
37 40 00 004700 Malfunction in the recording equipment, pin C8
28
S57
38 40 00 004800 Malfunction in the recording equipment, pin D1
28
S58
39 40 00 004900 Malfunction in the recording equipment, pin D2
28
S59
40 40 00 004A00 Malfunction in the recording equipment, pin D3
28
S60
41 40 00 004B00 Malfunction in the recording equipment, pin D4
28
S61
42 40 00 004C00 Malfunction in the recording equipment, pin D5
28
S62
43 40 00 004D00 Malfunction in the recording equipment, pin D6
28
S63
44 40 00 004E00 Malfunction in the recording equipment, pin D7
28
S64
45 40 00 004F00 Malfunction in the recording equipment, pin D8
28
S65
46 40 00 000139 General malfunction of the recording equipment S81, S82, S87, S92, S94, S95, S96, S97, S98,
S99, S105, S106, S108, S112, S113, S114,
S115, S119
47 80 00 001260 Driving without a proper card S67
48 40 00 C25900 Communication error with remote communication
equipment (DSRC)
S173, S174
49 40 00 C46B00 Missing position data of the GNSS receiver S171
50 40 00 F01762 Time conict (between GNSS and EFAS system clock) S86
51 40 00 000B80 VW CAN Time-Out Dimmung 01 S177
52 40 00 000D80 VW CAN Time-Out GW 71 S176
53 40 00 000F80 VW CAN Time-Out Reset S178
54 40 00 00FD0B CAN-Bus AUX in “Bus-O”-state S89
55 80 00 0001C0 Over Speed prewarning S100
12.4 Printout of Service IDs
Via the EFAS menu, the printout or display of the last 100 service IDs is possible (“SrvId” and “SrvId฀”). The printout of events/
faults is arranged chronologically in reversed order, i.e. the newest events and faults will appear at the top of the printout.
Duration “--h--” indicates an ongoing event or fault.
Since the list of service IDs within EFAS is never reset, and might be a little long, the user may interrupt the printout by means
of the key 9 at any time. EFAS records the last printout-time for this printout and shows it via the marker “” (last printout
time; see example below).
Note
EFAS records the last printout-time for this printout and shows it via the marker . The marker is useful when
you want to interrupt the printout at an adequate point by means of the key 9.
Note In the menu of the EFAS Service Tool the parameter “Printed Service IDs” (RDI=0xFDBA) can be set to values
between 0 and 250, whereby “0” deactivates the function “Printout of Service IDs”.
Via EFAS Service-Tool the parameter PrintoutServiceIdConguration (RDI=0xFDBA) may be set to values between 0
and 250, where 0 disables the function “Printout of Service IDs” within the EFAS menu.
28 This code is reserved in the standard ISO 16844-7, but recording is not necessary at present. EFAS does not support this error code.