MY22B01 - 12_1.0_26.08.2021
195
Troubleshooting, fault clearance and repair
9.1.7 Other drive system errors
Symptom Cause Remedy
Two beeps will sound if a
switch is pressed but the
switch cannot be oper-
ated.
Pressed switch mode has been deacti-
vated.
This is not a malfunction.
Three beeps are
sounded.
A fault or warning has occurred. This occurs when a warning or an error is shown on the on-
board computer. Follow the instructions for the code in Section
6.2 System Messages.
If an electronic gear shift
is used, pedal assistance
becomes weaker when
the gear is changed.
This is because the computer sets the
pedal assistance to the optimum level.
This is not a malfunction.
A noise can be heard
after switching.
Contact specialist dealer.
It is normal to hear a
noise coming from the
rear wheel when cycling
as normal.
The gear shift setting may not have
been made properly.
Contact specialist dealer.
If the pedelec is brought
to a stop, gear transmis-
sion does not switch to
the position pre-config-
ured in the functional
feature.
You may have applied too much pres-
sure on the pedals.
It is easier to change gears if you press onto the pedals gently.
Table 61: Other drive system errors
To Next Page
Loading...
