MIC IP starlight 7000i Troubleshooting | en 69
Bosch Security Systems User Manual 2017.11 | 1.2 |
“High Shock Event” appears in
English in the middle of the OSD until
the camera is reset.
The camera experienced a high shock event.
– Check the integrity of the mechanical parts and
the screws (especially on the yoke arms).
– If there is obvious and severe damage, stop using
the camera and contact your Bosch Service
Center for assistance.
– If no damage is evident, complete one of the
following steps:
a) Cycle the power on the camera.
b) Send command AUX OFF 65 to remove the
OSD message.
– If IVA is configured on your camera, the OSD
message may interfere with IVA operation.
To Next Page
Loading...
