Bosch MIC IP starlight 7000i - AUX Control; Intelligent Tracking; Special Functions

MIC IP starlight 7000i Operation via the browser | en 9
Bosch Security Systems User Manual 2017.11 | 1.2 |
Note: If the pre-position is already stored, a dialog box displays the message, “Overwrite
current pre-position?” Click OK to overwrite, or click Cancel to cancel the operation.
Click to display the selected pre-position in the video image.
3.1.4 AUX Control
With the tab AUX Control you can enter pre-programmed keyboard control commands. These
commands are composed of a command number plus the appropriate function key (Show pre-
position, Set pre-position, AUX on, or AUX off). A valid combination either issues a command
to the device or displays an on-screen menu.
(Refer to the “Keyboard Commands“ section of the manual for a list of all AUX commands for
your camera.)
Show pre-position
Click this button to display a pre-position.
Set pre-position
Click this button to set a pre-position.
AUX on
Click this button to activate an AUX command.
AUX off
Click this button to deactivate an AUX command.
3.1.5 Intelligent Tracking
Options for tracking objects within the region of interest appear in the panel.
When Intelligent Tracking is active, the tracking icon appears on the image along with
the lines that track moving objects.
Select Off, Auto or Click. If Click is selected, click on an object to track it.
3.1.6 Special Functions
Scan 360°
Click this button to start a continuous 360° pan. To stop the continuous pan, click a
directional control in the View Control tab.
Autopan
Click this button to pan the camera between user-defined limits.
Tour A / Tour B
Click one of these buttons to start the continuous playback of a recorded (guard) tour. A
recorded tour saves all manual camera movements made during the recording, including its
rate of pan, tilt and zoom speeds, and other lens setting changes.
To stop a tour, click a directional control in the View Control tab.
Focus
Click this button to activate the Auto Focus One Push mode on the camera.
The OSD displays the message, “Auto Focus: ONE PUSH.”
White light
Click this button to turn on the White light of the illuminator accessory (if available on your
camera).
Click this button again to turn off the White light.