English | 29
Note: The calculated mitre angle MTR can only be transferred for mitre
saws, for which the setting for vertical cuts is 0°. When the setting for ver-
tical cuts is 90°, the angle for the saw must be calculated as follows:
90° – displayed angle MTR = angle to be set for the saw.
"Compound Mitre" Measurement
The "Compound mitre" ("Compound MTR") measurement is used to calcu-
late mitre and bevel angles when two workpieces with multiple angles (e.g.
crown mouldings) have to join precisely.
First measure the spring angle SPR and the corner angle CNR. The measur-
ing tool will then calculate the mitre angle MTR and the bevel angle BVL.
Carry out the worksteps exactly in the given sequence.
Bosch Power Tools 1 609 92A 56P | (12.07.2019)
To Next Page
Loading...
