14 | English
1 609 929 V21 | (10.6.10) Bosch Power Tools
Technical Data
Declaration of Conformity
We declare under our sole responsibility that
the product described under “Technical data” is
in conformity with the following standards or
standardization documents: EN 60335 and the
directives 2006/42/EC, 2004/108/EC including
their amendments.
Technical file at:
Robert Bosch GmbH, PT/ESC,
D-70745 Leinfelden-Echterdingen
Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
30.12.2009
Assembly
f Before any work on the vacuum cleaner it-
self, pull the mains plug.
Note: For vacuuming, the permanent filter 11 al-
ways must be inserted. In addition, the dust bag
14 must be used when dry vacuuming.
Replacing/Inserting the Dust Bag
(see figure A)
– Unlock the latches 4 and remove the vacuum
lid 10.
– Pull off the full dust bag 14 from the connec-
tion flange toward the rear. Close the open-
ing of the dust bag by folding down the lid.
Remove the closed dust bag from the vacu-
um cleaner.
All-Purpose Vacuum Cleaner PAS 11-21 PAS 11-21 PAS 12-27 PAS 12-27 F
Article number
0 603 395 034 0 603 395 003
0 603 395 008
0 603 395 032
0 603 395 037
0 603 395 042
0 603 395 1..
0 603 395 2..
Rated power input W9001100 1100 1100
Power input, max.
W11001300 1300 1300
Frequency
Hz 50/60 50/60 50/60 50/60
Container volume (gross)
l2121 27 27
Dust bag contents
l661010
Vacuum, max.*
hPa 150 150 160 160
Airflow, max.*
m
3
/h 180 180 216 216
Weight according to
EPTA-Procedure 01/2003
kg 6.3 6.3 6.5 6.5
Protection class
/II /II /II /I
* measured at the blower
The values given are valid for nominal voltages [U] of 230 V. For lower voltage and models for specific countries,
these values can vary.
Please observe the article number on the type plate of your vacuum cleaner. The trade names of the individual vac-
uum cleaners may vary.
Dr. Egbert Schneider
Senior Vice President
Engineering
Dr. Eckerhard Strötgen
Head of Product
Certification
OBJ_BUCH-860-002.book Page 14 Thursday, June 10, 2010 5:46 PM
To Next Page
Loading...
