PAVIRO Call Stations Operation | en 43
Bosch Security Systems 2018.04 | 04 | F01U306899
– If the red indicator light of a selection button does not go
out, an alarm or high priority evac message is distributed in
the corresponding zone or zone group (see section
Indicators, page 36).
Call selection using the numeric keys feature
The numeric keys feature can also be used to select
programmed zones or zone groups. This can be useful, for
example, if the call station does not have a call station
extension.
– Make sure the NUMERIC KEYS option is set to ON in the
Configuration tab of the IRIS-Net software.
The key assignment is saved in IRIS-Net when the ON
button is disabled, but the numeric feature will not work.
See the IRIS-Net manual for more information.
– Press any number between 1 and 999 to enter one or more
zones or zone groups.
– Use the * key to indicate a zone group and the # key to
confirm the entry of a zone or zone group. A total of 16
zones/zone groups can be assigned at the same time.
For example to select zone groups 1 and 2 and zones 80,
and 90 select: *1# *2# 80# 90#.
– The selected zones and zone groups are shown in the
display.
For example: G1 G2 Z80 Z90.
– If an incorrect zone or zone group number is entered, a
beep is sounded to alert the user.
– To remove a zone or zone group from a list, reselect the
zone or zone group and then press the * key.
For example to remove zone group 1 from previous the list
select: *1*. The display will then show G2 Z80 Z90
– To remove all zones or zone groups from the list, press the
* key for longer than 3 seconds.
– To recall the last selected zone or zone group, press the #
key for longer than 2 seconds.
To Next Page
Loading...
