PAVIRO Call Stations Operation | en 45
Bosch Security Systems 2018.04 | 04 | F01U306899
General alarm
Notice!
The alarm trigger depends on the priority of the call station
from which the alarm is activated. The user can configure the
call stations from which an alarm may be triggered. If
configured, an alarm can also be triggered if the system is in
standby mode. A visual and possibly also acoustic signal is sent
to each call station in the system to indicate that an alarm is
active.
Alarm buttons can be configured in such a way that an alarm
signal is transmitted to all zones/groups. A general alarm signal
is transmitted to all zones/groups in the system. Pressing the
covered ALARM button triggers the alarm. The button
illuminates red during the alarm. An alarm has high priority, and
takes precedence over all announcements or signals except for
actions that are triggered from the central station. Pressing the
ESC button switches the alarm off again.
Selection alarm
Notice!
The alarm trigger depends on the priority of the call station
from which the alarm is activated. The user can configure the
call stations from which an alarm may be triggered. If
configured, an alarm can also be triggered if the system is in
standby mode. A visual and possibly also acoustic signal is sent
to each call station in the system to indicate that an alarm is
active.
Alarm buttons can be configured in such a way that an alarm
signal is only transmitted to certain zones/groups that have
been previously selected. As with the selection call, the zones/
groups to which an alarm is to be transmitted must be selected
To Next Page
Loading...
