Bosch PAVIRO PVA-1WEOL - Mount the module; Set the module address

6
en | Installation
PAVIRO End-of-line supervision
module
2019-01 | V2 | F01U350870 Bosch Security Systems B.V.
Mount the module
!
Caution!
Make sure all safety regulations are observed. Mounting the
module on spacers is strongly recommended.
Set the module address
Before connecting the module, a module address must be set with the
DIP switches S2 and S1 (see previous figure and following table). The
module address allows for identification of the affected loudspeaker
line in case an error occurred, such as an open-circuit.
6 5 4 3 2 1 Module
address
DIP switch S2 DIP switch S1
4 3 2 1 4 3 2 1
OFF OFF OFF OFF OFF OFF 0 (not
connected)
OFF OFF OFF OFF OFF ON 1
OFF OFF OFF OFF ON OFF 2
OFF OFF OFF OFF ON ON 3
OFF OFF OFF ON OFF OFF 4
OFF OFF OFF ON OFF ON 5
OFF OFF OFF ON ON OFF 6
OFF OFF OFF ON ON ON 7