PAVIRO Router Installation | en 11
Bosch Security Systems, B.V.
User manual
2022-11 | 07 | F01U306901
5 Installation
This device has been designed to be installed horizontally in a conventional 19” rack cabinet.
Front attachment of the device
Refer to the following illustration to attach the front of the device, using four screws and
washers. Because of painted surfaces the connection of the grounding screw at the rear panel
of the device is recommended.
Figure5.1: Installation of the device into a 19" rack
Caution!
The use of rack mount rails is recommended when installing the device in a rack shelf or rack
cabinet to prevent the front panel from twisting or warping. If devices should be stacked in
the rack (e.g. using the self-adhesive foot stands supplied) the maximum permissible load of
the mount rails must be considered. Please refer to the technical specifications provided by
the rack rail manufacturer.
Figure5.2: Stacking of devices using the supplied foot stands (example with 3 devices, rack mount rails
are used for the bottom device only)
The device must be protected from:
– Dripping water or spray
– Direct sunlight
– High ambient temperatures or immediate sources of heat
– High humidity
– Large dust deposits
– Strong vibrations
To Next Page
Loading...
