Bosch PAVIRO PVA-4R24 - Control Input and Output Ports

18 en | Connection PAVIRO Router
2022-11 | 07 | F01U306901
User manual
Bosch Security Systems, B.V.
minimize these reflections, these stub lines must not exceed a maximum individual length of
2m at data transmission rates of up to 125kbit/s, or a maximum length of 0.3m at higher bit
rates. The overall length of all branch lines must not exceed 30m.
The following applies:
– In terms of rack wiring, standard RJ-45 patch cables with 100-ohm impedance (AWG24/
AWG26) can be used for short distances (up to 10m).
– The guidelines specified above for the network cabling must be used when wiring the
racks with each other and for the building installation.
6.5 Control input
There are two control input ports (input 1-5 or 6-10) on the rear of the device.
The CONTROL IN port is split into two halves:
– The upper half has five freely configurable supervised, not isolated control inputs.
– The lower half has five freely configurable isolated control inputs.
The delivery includes 10-pole connectors. Conductor cross-sections of 0.14 mm² (AWG26) to
1.5 mm² (AWG16) can be used. Recommended connecting cable: shielded flexible stranded
wire, LiY, 0.5 mm². The control port is configured in IRIS-Net.
!
Caution!
The maximum permissible voltage on a control input is 32 V.