20 en | Installation PAVIRO Call Stations
2018.04 | 04 | F01U306899 Bosch Security Systems
5.2 Button labeling
The call station buttons are labeled using labeling strips, which
are inserted from above. Execute following steps to label the
buttons:
1. Carefully loosen the transparent cover on the top using the
included release tool. A provision for releasing the cover is
made at the top of the cover on the right side of the
microphone.
2. Insert the release tool into the provision for release and
move the tool to the right side.
3. The top snaps will release from the housing.
4. Insert the tool at the left side of the microphone and move
to the left.
5. Now the cover can be removed.
6. Insert the labeled paper strips into the label fields.
7. Reattach the transparent cover: Align the bottom cover
snaps with the holes in the call station housing, then push
the top cover snaps gently and equally into the holes.
To Next Page
Loading...
