22 en | Installation PAVIRO Call Stations
2018.04 | 04 | F01U306899 Bosch Security Systems
1. Disconnect the call station from all connectors.
2. Unscrew the call station baseplate (4 screws ➊).
3. Carefully remove the baseplate from the upper part, start
on the top left corner of the call station.
4. Unplug the connecting cable from the CN1 plug connector
➋.
5. Prepare installation location ➌: Use a sharp object (scriber
or similar) to carefully punch through and cut out the pre-
cut rectangle on the inside of the housing. Perform any
follow-up work that may be required to the installation
location (e.g. filing, trimming).
To Next Page
Loading...
