15
Before any work on the machine itself, pull the
mains plug.
For safe and proper working, always keep the
machine and the ventilation slots clean.
Clean the tool mount daily.
Replacing the Dust Protection Cap
Damaged dust protection caps should be replaced
as soon as possible since dust that enters the tool
holder can cause malfunctions.
Pull back and hold the locking sleeve 5. Pull off the
dust cap 4 with a suitable tool.
With the locking sleeve pulled back, pull on the new
dust cap until it sits firmly over the tool holder and the
locking sleeve can again be slid forward.
If the machine should happen to fail despite the care
taken in manufacture and testing, repair should be
carried out by an authorised customer services agent
for Bosch power tools.
For all correspondence and spare parts orders, always
include the 10-digit order number of the machine.
WARNING
Important instructions for connecting a new 3-
pin plug to the 2 wire cable.
The wires in the cable are coloured according to the
following code:
Do not connect the blue or brown wire to the earth
terminal of the plug.
Important: If the plug on the cable of this machine
must be replaced, dispose of the old plug to prevent
misuse.
Recycle raw materials instead of disposing as
waste.
Machine, accessories and packaging should be
sorted for environment-friendly recycling.
These instructions are printed on recycled paper
manufactured without chlorine.
The plastic components are labelled for categorized
recycling.
Great Britain
Robert Bosch Ltd. (B.S.C.)
P.O. Box 98
Broadwater Park
North Orbital Road
Denham-Uxbridge
GB-Middlesex UB 9 5HJ
✆ Service . . . . . . . . . . . . . . . . . . . . (01895) 83 87 82
✆ Advice line . . . . . . . . . . . . . . . . . (01895) 83 87 91
FAX. . . . . . . . . . . . . . . . . . . . . . . . . (01895) 83 87 89
Ireland
Beaver Distribution Ltd.
Greenhills Road
IRL-Tallaght-Dublin 24
✆ Service . . . . . . . . . . . . . . . . . . . . . (01) 4 51 52 11
FAX. . . . . . . . . . . . . . . . . . . . . . . . . . (01) 4 51 71 27
We guarantee Bosch products in accordance with
statutory/country-specific regulations (proof of
purchase by invoice or delivery note).
Damage attributable to normal wear and tear,
overload or improper handling will be excluded from
the guarantee.
In case of a claim, please send the machine,
completely assembled, to your dealer or the Bosch
Service Centre for electric power tools.
We declare under our sole responsibility that this
product is in conformity with the following standards or
standardization documents: EN 50 144, EN 55 014,
EN 60 555, HD 400 according to the provisions of the
regulations 73/23/EEC, 89/336/EEC, 89/392/EEC.
96
Dr. Alfred Odendahl Dr. Eckerhard Strötgen
Robert Bosch GmbH, Geschäftsbereich Elektrowerkzeuge
Maintenance and Cleaning
Environmental Protection
strain relief
live = brown
neutral = blue
To be fitted
by qualified
professionals only
Service
Guarantee
Declaration of conformity
Specification subject to alteration without notice
pbh220_bu_1609929B38_t.fm5 Seite 16 Montag, 19. April 1999 3:07 15
To Next Page
Loading...
