Cleaning and servicing en
7
Dis-
play
Selection
Time for selecting hotplates
– Unlimited: The last hotplate selected can
always be adjusted without having to select it
again.
1
– You can adjust the last hotplate selected
within 10seconds after selecting it. After this
time you have to select the hotplate again be-
fore adjusting it.
Resetting to the factory settings
– Switched off.
1
– Switched on.
1
Factory setting
7.2 Changing basic settings
Requirement:The hob is switched off.
1.
Switch on the hob.
2.
Within the next 10seconds press and hold and
for 4seconds.
a and flash alternately on the lower display.
a lights up on the upper display.
3.
Touch repeatedly until the required indicator ap-
pears on the lower display.
4.
Use or to set the required value.
5.
Simultaneously press and hold and for
4seconds.
a The setting is activated.
Tip:To exit the basic settings without saving, switch off
the hob using . Switch the hob on again and reset.
8 Cleaning and servicing
To keep your appliance working efficiently for a long
time, it is important to clean and maintain it carefully.
8.1 Cleaning products
You can obtain suitable cleaning products and glass
scrapers from customer service, the online shop or a
retailer.
ATTENTION!
Unsuitable cleaning products may damage the sur-
faces of the appliance.
▶
Never use unsuitable cleaning products.
Unsuitable cleaning products
¡ Undiluted detergent
¡ Detergent intended for dishwashers
¡ Abrasive cleaners
¡ Aggressive cleaning products such as oven spray
or stain remover
¡ Abrasive sponges
¡ High-pressure or steam jet cleaners
8.2 Cleaning the glass ceramic
Clean the hob after every use to stop cooking residues
from getting burnt on.
Note:Note the information on unsuitable cleaning
products. →Page7
Requirement:The hob has cooled down.
1.
Remove heavy soiling using a glass scraper.
2.
Clean the hob with a cleaning product for glass
ceramic.
Follow the cleaning instructions on the product
packaging.
Tip:You can achieve good cleaning results using a
special sponge for glass ceramic.