Bosch Plena Voice Alarm System - Page 25

Plena Voice Alarm System System overview | en 25
Bosch Security Systems B.V. Installation and Operation manual 9922 141 1037x (V2.16) | V0.6 | 2011.09
5. Emergency call zone selectors:
Six buttons to select the zones to which the emergency call must be distributed (see
section 7.4 ). Each button has a green and a red LED. The six red LEDs indicate the zones
that are selected for the emergency call. The six green LEDs indicate the zones in which a
business call is running.
6. BGM zone selectors:
Six buttons to select the zones to which the BGM is distributed (see section 7.2 ). Each
button has a green LED. The six green LEDs indicate the zones to which BGM is
distributed. It is not possible to control the volume of the BGM with the remote control.
7. All call button:
A button to select all zones. This button is only available in the emergency state (see
section 7.4 ).
8. Indicator test button:
A button to test all LEDs on the front panel of the remote control and all connected
remote control extensions. All LEDs are lit as long as the button is pushed (see section
7.5 ).
9. Emergency button:
A push button to put the system in the emergency state (see section 7.4 ).
10. Alert message button:
A button to select the alert message. This button is only available in the emergency state
(see section 7.4 ).
11. Alarm message button:
A button to select the default alarm message. This button is only available in the
emergency state (see section 7.4 ).
12. Microphone socket:
A socket to connect the hand-held emergency microphone (see section 5.1.1 ).
13. Bracket:
A bracket for the hand-held emergency microphone that is supplied with the remote
control.
14. Monitoring loudspeaker:
Built-in monitoring loudspeaker.
15. Ground:
A connection to electrically ground the remote control.
16. Firmware upgrade connector:
An RS232 connector to connect a PC to upgrade the firmware of the remote control.
17. Firmware upgrade switch:
A switch to upgrade the firmware of the remote control.
18. Remote control extension sockets:
Two redundant RJ45 sockets to connect remote control extensions to the remote control
(see section 5.4.2
).
19. Configuration settings:
A set of DIP switches to configure the remote control (see section 6.5 ).
20. Controller socket:
One RJ45 socket to connect the remote control to the voice alarm controller (see section
5.4.1 ).
21. Emergency microphone volume control:
A rotary knob to set the volume of the hand-held emergency microphone.