Bosch Plena Voice Alarm System - 3.7 Voice Alarm Remote Control kit

26 en | System overview Plena Voice Alarm System
9922 141 1037x (V2.16) | V0.6 | 2011.09 Installation and Operation manual Bosch Security Systems B.V.
22. Monitoring speaker volume control:
A rotary knob to set the volume of the monitoring loudspeaker.
23. Trigger outputs:
Three general purpose trigger outputs. For future use.
24. Status outputs:
Three status outputs to send the status of the Plena Voice Alarm System to third party
equipment (see section 5.4.3 ).
25. 24 V DC input:
One 24 V(DC) input to connect the remote control panel to a power supply (see section
5.4.4 ).
3.7 Voice Alarm Remote Control kit
With the Voice Alarm Remote Control Kit, it is possible to make customized remote controls
that can be connected to the voice alarm controller. The remote control kit provides the same
functionality as the Voice Alarm Remote Control.?
See Figure 3.10 for an overview of the front panel of the remote control kit. The rear panel of
the remote control kit is the same as the rear panel of the Voice Alarm Remote Control (see
Figure 3.9).
Figure 3.10 Front and rear views of the remote control kit
BGM Zone 1
BG M Zone 6
BGM Zone 5
BGM Zone 4
BGM Zone 3
BGM Zone 2
Call Zone 6
Speaker
Power
EMG Ack
EMG Reset
Processor
reset
Network
Call/EMG.
Music/
Spare
Ground
short
Input
Mains
Zone 1~6B
Zone 1~6A
RCP Ext.
Controller/Router
EMG mic
Message
Battery
Call Zone
Indicator 1~6
EMG Zone Indicator 1~6
GND
BGM Zone Indicator 1~6
GND
EMG State Lamp
+
_
-20dB
-6dB
0dB
Disable
Alert Message
Alarm Message
EMG Mic
EMG Switch
Alert Message
Alarm Message
All call
Indicator test
Fault Ack
Fault Reset
Call Zone 1
Call Zone 2
Call Zone 3
Call Zone 4
Call Zone 5
Plena Voice Alarm Remote
Control Kit
LEDS/LAMPS
200mA Max. input
LED
S/LAMPS
200mA Max. input
LEDS/LAMPS
200mA Max. input
Call/BGM
Zone selection
GND 24V out
0.2A
5K ohm
< 5mA
24V out
LEDS/LA MPS input
123456 123456 12
3456
123456123456
EMG mic
External Power Supply
200mA max.
50V DC max.